URGENT WARNING
TOYOTA EMBROIDERY MACHINES

CRASHED                                                          TRIM MODE
ENGINEERING OF THIS MACHINE IS TOP QUALITY SEWING AND MECHANICAL PARTS BUILT AS A TAJIMA MACHINE IN THE FACTORY
WHO PRODUCE TAJIMA
THE TOYOTA MACHINE NOT THE TAJIMA AS A SOFTWARE OR DESIGN PROBLEM
AS WITH ALL EMBROIDERY MACHINES OVER 90% OF ALL BREAKDOWNS ARE CAUSED BY THE NEEDLE BAR CRASHING INTO THE HOOP THIS CAN PROVE VERY COSTLY, EACH TIME THIS HAPPENS THIS IS DOING DAMAGE TO YOUR MACHINE  IT CAN CAUSE THE FOLLOWNG PROBLEMS DAMAGE TO A NEEDLE BAR, THE TAKE UP SYSTEM TO GO OUT OF TIME GIVING YOU A PROBLEM WITH COLOUR CHANGE OR IT CAN BREAK THE RECIPROCATOR SO THE MACHINE WILL NOT OPERATE  ANY OF THE PROBLEMS CAN BE COSTLY IN DOWN TIME AND SERVICE CALL IF THIS IS DONE BY OPERATOR ERROR THAT IS ACCEPTABLE WHEN THIS IS DOWN TO A FAULT IN THE MACHINE THIS IS NOT ACCEPTABLE I AM AWARE OF 3 MACHINES WITH THE FOLLOWING PROBLEM THE MACHINE CAN BE IN THE MIDDLE OF A DESIGN WHEN FOR NO REASON THE HOOP WILL FLY OVER AS THE PHOTO ON THE LEFT ABOVE SHOWS AND CRASH INTO THE HOOP  SMASHING THE NEEDLE  ANOTHER PROBLEM SIMILAR IN MIDDLE OF DESIGN FLY OVER THE GO IN TO CONSTANT TRIM MODE UNTIL YOU STOP THE MACHINE CAUSING A HOLE IN THE GARMENT WHEN ONE OF THESE FAULTS ARISE YOU HAVE TO CLEAR THE MEMORY AND RE PUT THE DESIGNS INTO YOUR MACHINE ALL THIS IS NOT A NEW PROBLEM THIS AS BEEN GOING ON FOR 2 YEARS A RECENT MACHINE ONLY 3 MONTHS OLD SMASHED INTO THE FRAME CAUSING THE RECIPROCATOR TO BREAK ONLY AFTER CONSTANT DISCUSSION DID ASIN TOYOTA AGREE TO REPAIR MACHINE UNDER WARRANTY  AISIN UK DO NOT NOW HAVE A ENGINEER AS HAVE RECENTLY MADE THE ENGINEER REDUNDANT WHO IS NOW WORKING FOR HIMSELF AT THE TIME OF ABOVE BREAKDOWN NO AISIN ENGINEER WAS AVAILABLE AND HAD TO ASK A LOCAL ENGINEER TO REPAIR MACHINE THIS IS NOT ACCEPTABLE FROM A PROFESIONAL COMPANY 2 OF THE ABOVE MACHINES THE DESIGNS WERE PRODUCED ON WILCOM THE NUMBER 1 IN DIGITIZING  THIS IS NOT A PROBLEM CAUSED BY THE DESIGN THIS IS A PROBLEM WITH THE TOYOTA MACHINE IF YOU HAVE HAD THIS OR SIMILAR PROBLEMS PLEASE EMAIL